I love to use my ScanNCut when I art journal. I recently created this page in my art journal:
The silver foil stars were cut with my ScanNCut, but not in the way you might think!
Here’s the easy peasey technique:
STEP ONE: Cut shapes from paper. For this tutorial I’ve used my ScanNCut to cut out some cuts of my handwriting. For the how-to on cutting your own handwriting with the ScanNCut, watch this tutorial:
I used my deep cut blade to cut up an old Equal box because I wanted my cuts to be thicker than paper.
I used a “7″ on my deep cut blade. Your machine may be different. Be sure to do a test cut first!
STEP TWO: Place foil tape over your shapes, slightly overlapping strips of tape.
Foil tape (or duct tape) is something you can buy at the hardware store. I believe it’s used for repairing duct work. You can also buy large sheets of adhesive backed foil from your craft store if you don’t want seams.
STEP THREE: Rub well, especially down into the crevices of the paper underneath. Be careful not to pierce the tape.
Usually I start with my finger and then move onto a tool like a bone folder.
STEP FOUR: Paint over the top of the foil and allow the paint to dry. I used black gesso, but you could use any acrylic paint.
STEP FIVE: Once the paint is dry, sand it. Where the chipboard is underneath, the foil is raised and you will remove the paint when you sand it.
You can sand a lot or a little depending on the look you want.
Note: If there are wrinkles in your foil tape, they will also catch the sandpaper. This is why it’s important to spend some time smoothing everything down in step #3.
Here’s the final result:
Pretty darn cool, right? In person, it really glows and shines!
See you next week!