DIY! Till You Drop!

July 29, 2019By Brother ScanNCutProjects, Vinyl Décor Opinion by Paid Consultant

Wouldn’t you rather DIY than BUY? Well then, use heat-transfer vinyl glitter and transform a basic t-shirt into a fashion statement!

You will need:

A T-shirt, glitter heat-transfer vinyl, iron, scrap fabric, ScanNCut, standard mat

Steps:

  1. Download diy till u drop.fcm to your machine. Trim a sheet of heat-transfer vinyl film to about the width and height of the design, using the scanning function if needed to make sure that everything is aligned.
  2. Flip the design on the machine using the Object Edit menu. This will ensure that the saying will not come out backwards once cut out and adhered to the fabric!
  3. Select “Cut” on the next screen. Go into the menu options and make sure that half cut is selected (on the DX, you can use all auto settings when half cut is turned on to get the correct cut). Otherwise, you’ll need to calibrate your blade to make sure that you only cut through the adhesive part of the vinyl (not shiny side) and not the carrier backing (shiny side).
  4. Place the glitter vinyl carrier side (shiny side) down on the mat.
  5. Cut out the design. Glitter HTV is typically thicker than film vinyl, so you may need to increase blade pressure or adjust manual blade settings to get a good cut.
  6. Weed out all unneeded vinyl so that only the design remains on the sticky clear carrier sheet.
  7. Now it’s time to begin adhering the vinyl to the shirt! Place the graphic down on the shirt, and move the piece around until you get an alignment you like. Note that the sticky carrier should stick to the fabric, and through the clear sheet you should be able to see your design that is at the correct orientation (not reversed).
  8. Place a piece of scrap fabric over the vinyl carrier sheet. Set an iron to medium-high heat (or the setting recommended by HTV instructions), with no steam.
  9. Using a firm pressing motion, iron over the scrap fabric to seal the HTV to the t-shirt. Make sure to press firmly on the edges.
  10. Let the carrier sheet cool for a few seconds before touching it, then carefully peel the carrier sheet off. The design should remain firmly on the t-shirt.
  11. You’re done!